Page 1 of 1

How put WG3526 in bridge / pass through mode

Posted: Mon Feb 22, 2021 6:46 pm
by Dre40
Have a mofi 4500 and LTEFix WG3526 load balanced by a TL-R600VPN (cat5 from that to PCs) and then a Wifi5 TP Link 1900AC router for good strong wifi (covers every spot in the home, antennas in LTE routers turned off). Speeds range from 5-20mb (I am a long way from towers/lots of trees this is best I can get, peaks sometimes near 40 though)

I can't figure out how to put the WG into bridge mode

Re: How put WG3526 in bridge mode

Posted: Thu Mar 04, 2021 9:29 pm
by Dre40
Edit: Found in search: ... dge#p16979

Sounds like it is not possible with the openWRT software on WG3526? That still the case? Should I switch to something else (software wise)?

Edit 2: Will try this: ... 0c1#p15084