Trouble with AT-command terminal.

Related to Router Devices ONLY
Post Reply
Eric592
Posts: 2
Joined: Sat Mar 16, 2019 4:13 pm

Trouble with AT-command terminal.

Post by Eric592 » Sat Mar 16, 2019 4:35 pm

I’m new to this custom router stuff! I built a router using a raspberry pi 3 b and a SIERRA WIRELESS module MC7455 LTE 4G module I’m connected to the internet and was able to use my at commands before but now when I try to type a command it just disappears while typing it. is there something I’m doing wrong?

swwifty
Posts: 414
Joined: Thu Aug 30, 2018 8:21 pm
Location: NE GA Mountains

Re: Trouble with AT-command terminal.

Post by swwifty » Sun Mar 17, 2019 3:16 pm

I've seen this with the latest version of GoldenOrb. Is that what you're running?

I recall too that some users have to put there modem in QMI or MBIM mode for this to work as well. I have a MC7455 that I run in MBIM mode just fine, but on a older version of GoldenOrb (from last year).

Eric592
Posts: 2
Joined: Sat Mar 16, 2019 4:13 pm

Re: Trouble with AT-command terminal.

Post by Eric592 » Sun Mar 17, 2019 5:32 pm

I figured it out finally i got it up and going now. I found a few post on how to reset the modem and stuff back to oem and just redid the at commands works fine now!

Post Reply
  • Similar Topics
    Replies
    Views
    Last post